Thermoset PI vs. Spruce-pine-fir
Thermoset PI belongs to the thermoset plastics classification, while spruce-pine-fir belongs to the wood-based materials. There are 13 material properties with values for both materials. Properties with values for just one material (16, in this case) are not shown. Please note that the two materials have significantly dissimilar densities. This means that additional care is required when interpreting the data, because some material properties are based on units of mass, while others are based on units of area or volume.
For each property being compared, the top bar is thermoset PI and the bottom bar is spruce-pine-fir.
Metric UnitsUS Customary Units
Mechanical Properties
| Compressive (Crushing) Strength, MPa | 120 to 210 | |
| 50 |
| Elongation at Break, % | 2.0 to 5.9 | |
| 1.5 |
| Tensile Strength: Ultimate (UTS), MPa | 37 to 81 | |
| 85 |
Thermal Properties
| Maximum Temperature: Mechanical, °C | 260 | |
| 130 |
| Specific Heat Capacity, J/kg-K | 1130 | |
| 1380 |
| Thermal Conductivity, W/m-K | 0.29 to 1.7 | |
| 0.12 |
| Thermal Expansion, µm/m-K | 38 to 54 | |
| 6.5 |
Electrical Properties
| Dielectric Strength (Breakdown Potential), kV/mm | 20 | |
| 0.5 |
Otherwise Unclassified Properties
| Density, g/cm3 | 1.4 to 1.6 | |
| 0.5 |
| Limiting Oxygen Index (LOI), % | 40 | |
| 24 |
Common Calculations
| Strength to Weight: Axial, points | 6.5 to 16 | |
| 47 |
| Strength to Weight: Bending, points | 16 to 30 | |
| 86 |
| Thermal Diffusivity, mm2/s | 0.18 to 0.95 | |
| 0.17 |